Do you do fabrication work?

We have a list of vendors that we use to complete any fabrication work, we are your one stop shop.

Can I have my part tomorrow?

Being a job shop quick turn work is one of our specialties. We will do everything we can to get our customers what they need!

What size of a part can usually run?

CNC lathe machines can run parts up to 26” in diameter and parts up to 120” long.

Can you machine plastic?

Yes, we have quite a bit of experience machining plastic along with a gantry router that will accommodate up to 5’ x 10’ sheets with precision machining.

How are you going to check the tolerances?

We have a well qualified and tooled quality department. We have a micro-Hite and Romer arm that we use to assist in dimensional measurements.

Can you paint this?

We have an approved list of vendors that handle all of our painting and coating needs.

What kind of coatings do you do?

  • Xylan
  • Epoxy
  • Carboline
  • TSA Coating

Where are you located?

East side of Houston near Beltway 8 and Wallisville Road. We are about 20 minutes from Downtown Houston.

You can also find our address at the bottom of the page or visit our Contact Us page to see a map of our location.

Are you ISO certified?

Yes, we are an ISO 9001:2008 Registered Company.

Can you machine close tolerances parts?

Yes, we can typically hold tolerances in the tenths depending on the application.

Do you assemble?

Yes.

How long are your work quotations valid?

Usually 30 days unless otherwise specified.

Do you do short runs or proto-type machining?

Yes, 1 or 2 parts not a problem.

Do you have fabrication abilities?

Not in house but have several qualified outside vendors.

Go to Top